Trouble Shooting Residential Tanning Beds
Aus Bildungsstreik 2009
A residential tanning bed is often bought by people who want to have a tan with out bothering to dress up and go to a tanning salon. A tanning bed at house tends to make it more convenient for a individual to get that superb tan. But a residential tanning bed also implies further duty for the owner. Technology is in no way ideal smtp list, like the humans who use them. As a result smtp list, the property tanning bed may possibly be subject to many problems. Luckily, the owner of such tanning bed need not call a technician every single time some thing goes wrong with it. Right here is a guide that will be valuable for the owner of a residential tanning bed.
If the bed refuses to begin or to turn on, there could be four possible causes:
1. There is no energy supplied to the bed
2. There is a negative relay
3. There is a loose at the relay
four. There is a loose wire at the dial timer
The owner should inspect the plug and the breaker to make positive that there is power going to the bed. If the relay is bad, then there is no other way to fix the bed but to replace the relay. As for loose wires, all the owner has to do is to tighten the loose connection.
If the lamps dont light up, there are 5 possible causes:
1. Malfunctioning lamps
two. Malfunctioning ballast
3. Malfunctioning lamp holder
four. Malfunctioning starter
five. A loose wire at the ballast, or at the lamp holder or at the terminal
For any malfunctioning component of the tanning bed, the owner will want to replace it. The owner should not try to repair it by himself. For the loose wire, the owner may just tighten the loose connection.
If the bench lamps will not light up, the lead to could be any of these:
1. The bench is not plugged into the canopy
2. A loose wire in the connector among the bench and the canopy
three. The wire in the bench-to-canopy connector may be burnt
The owner need to check if the bench is securely plugged into the canopy. If not, he should correct the scenario. The loose wire necessary only a tightening. But if the wire is burnt, the owner need to retrieve some electrical tools so that he can strip the wire and replace the connector.
If the lamps do not function nicely but the fans are operating fine, there are only two factors to check:
1. The relay
2. The wire either at the terminal block or the relay
The owner need to verify whether or not the relay is malfunctioning or not. If it is not functioning appropriately, this relay ought to be replaced. Any loose wire at the terminal block or at the relay can be corrected by tightening the connection.
For other tanning bed troubles, it is greatest that the owner consults the technician of the tanning bed supplier.